Etched Stainless steel
Standard Thicknesses:
1/16″, 1/8″, 1/4″ deep
Standard Square Inches:
1″–1,500″ sq. in. (1,500″ sq. in. + email for quote)
Chemical etching allows us to transfer the most complex artwork to a range of metals. Combined with cast and precision tooled plaques, etched medallions and emblems provide the precision needed to accentuate any plaque marker.
Premium etched plaques in brass, bronze or stainless steel and can be produced as thin as 1/16″ thick.
Etched photos are created with halftone images to provide a permanent, exterior-grade solution.
We have a stringent in-house laboratory testing process for all metals and paints. Our finishes have withstood thousands of hours of exposure to salt, fog, moisture, heat cycles, and UV light, so we can confidently say they’ll last a lifetime.
Our Authorized Partners can sign in to their Partner Portal and use TrueQuote to get an instant quote. If you’re not a partner, you can visit our partner locator page to get in touch with a Gemini partner near you.
Gemini has always exceeded my expectations. Quality is outstanding. Customer service outstanding. A great partnership.
Standard Thicknesses:
1/16″, 1/8″, 1/4″ deep
Standard Square Inches:
1″–1,500″ sq. in. (1,500″ sq. in. + email for quote)
Standard Thicknesses:
1/16″, 1/8″, 1/4″ deep
Standard Square Inches:
1″–1,500″ sq. in. (1,500″ sq. in. + email for quote)
Standard Thicknesses:
1/16″, 1/8″, 1/4″ deep
Standard Square Inches:
1″–1,500″ sq. in. (1,500″ sq. in. + email for quote)
Standard Thicknesses:
.022″, .029″, .05″ deep
Standard Square Inches:
1″–80″ sq. in.
Standard Thicknesses:
.018″, .04″ deep
Standard Square Inches:
1″–80″ sq. in.
Standard Thicknesses:
.025″, .05″ deep
Standard Square Inches:
1″–80″ sq. in.
Standard Thicknesses:
.02″, .04″ deep
Standard Square Inches:
1″–80″ sq. in.
Standard Thicknesses:
.02″ deep
Standard Square Inches:
1″–80″ sq. in.
For more information on installation instructions and videos, product drawings and information on mounting patterns, visit the Installation page.
All etched plaques 1/4” thick and thicker are drilled and tapped. View drawing
Plaques thinner than 1/4” can be stud mounted with welded stud bosses.
Strips of very high bond tape are applied to the back of the plaque. Interior use only. Size limitations apply
Holes are drilled through the surface of the plaque. Specify screw size and if the holes should be countersunk. (Plaques 1/16” thick cannot be countersunk and will include round head screws.)